Copyright © 2011-2024, Paul Scrivens-Smith

Copyright © 2011-2024, Paul Scrivens-Smith

All rights reserved. This work may not be reproduced, in whole or in part, without the prior written permission of the creator.

Thursday 16 May 2013

A couple of sections of Gurkha

Over the past few days I've finished off sixteen Gurkha for my Burma 1945 project. Two sections of eight Gurkha with a SMG (Sten or Thompson), six SMLE Rifles and a BREN gun.

Lovely figures full of character, from The Assault Group and really easy to paint. I did them as follows:


  • Clean up figures and stick on 25mm round MDF bases
  • Prime them with Halfords white primer (I usually use grey but had run out)
  • An all over wash of Vallejo Beige Brown, Vallejo Glaze Medium and water.

I then rough out a base coat as follows:

  • Vallejo Gunship Green: Shirts, trousers, some hats, some webbing, some gaiters, some packs, some water bottles
  • Vallejo Khaki:  Rifle slings, some hats, some webbing, some gaiters, some packs, some water bottles.
  • Vallejo Chestnut Brown: Rifle stocks, entrenching tool handles, bayonet handles, some boots.
  • Vallejo Black: Bayonets, Rifle fittings, some boots.
  • Vallejo Saddle Brown & Vallejo US Tan Earth : Exposed flesh.

Once the figure is base coated I give the figure a wash of Vallejo Sepia Wash. Once dry I apply the highlights as follows:

  • Gunship Green areas: Highlight with Gunship Green then highlight again with a mix of Gunship Green & Dark Sand
  • Khaki areas: Highlight with Khahi then highlight again with a mix of Khaki & Dark Sand
  • Chestnut Brown areas: Highlight with Chestnut Brown then highlight again with a mix of Chestnut Brown & Dark Sand
  • Black areas: Highlight with Black Grey for the boots 
  • Black areas: Highlight with a mix of Gunmetal Grey and Black for the bayonets and rifle fittings, then bayonets are then further highlighted in Gunmetal Grey
  • Exposed flesh highlighted with US Tan Earth then highlighted again with Tan Yellow.

Once the highlights are done then the detail is picked out with Windsor and Newton Peat Brown ink.

The bases are then covered in PVA glue and dipped in a coarse sand mix that is painted Vallejo US Field Drab, highlighted with Vallejo Dark Sand and then washed with Vallejo Sepia Wash then decorated with tufts and scatter.



Here are a load of close-ups:












3 comments:

  1. Great looking Ghurkas, Paul. I like TAG figures too. Best, Dean

    ReplyDelete
  2. These are really excellent work. Very nice indeed.

    ReplyDelete